We needed a new dog bed. OK actually, the dog needed a new bed. Here is the sad “before” state.
Dog beds cost like $25-40. That’s just silly. It’s some fabric and stuffing. So, we got some supplies. A throw blanket from Wal Mart ($2.87). Iron-on seam tape ($3.97). And the best part – we had a couple of old study-buddy pillows that were ready for donation to the thrift store, where they would no-doubt sit endlessly waiting for one of the tens of people in the world who buy used pillows to stumble on them. Since everyone has some old pillows of some type lying around for stuffing, total cost for the dog bed: $6.00.
We were a little worried about the seam tape, whether it would be permanent, and whether it would adhere well to the blanket material. This ultrabond stuff worked well.
Fold the blanket in half. The seam tape is double-sided, so you put it between the blanket seam and iron it down on one side. You can press the iron for just a few seconds at this point.
Then fold the blanket over, pull back the other side of the tape, and iron it down. At this point, you need to press down hard with the iron for about 10-15 seconds to get adequate heat to transfer through the material.
Once you’ve done 3 sides, you’re ready to stuff away!
Then you iron closed the final seam. Of course you could have turned it inside out before stuffing it, and then closed it up, but we liked the visible seam edges better. And our approach seemed like it put less stress on the seamed edges than if it were inside out.
And now for the after-shot! Happy dog.