Ethan and I decided to make some steampunk’ish desk lamps out of black pipe this weekend. There are lots of various designs and tutorials out on the web, but we just got ourselves a bunch of parts and assembled things until we found a structure we liked.
The main parts you need to create one of these are pipe lengths (we used 10″ and 3″ sections), elbows (we used 45 and 90 degree ones), flanges (the round, flat base things), lamp sockets, 1/2″ to 3/4″ reducers (for the little feet as an alternative to the flanges), Tee shapes, and some old electrical cord/plugs. Ours was made of 1/2″ parts, but you could move up to 3/4″ for a larger lamp. Depending on your design, you might also find a use for the end caps.
We added the brass water water spout to break thing up, but ended up not liking it. I think we’re going to replace the water spout with something less modern-looking.
Oh, and you need light bulbs of course. Check out these two versions. They are vintage, filament-type bulbs that GE sells and that you can find at most home supply stores. They really help to give your lamps that vintage, industrial and/or steampunk look. Beware, these bulbs put off a lot of heat and get very hot, so you’ll want to be careful about the type of fixture you put them in (see below).
For the bulb covers, we used a couple of those hanging portable lights that are common in auto shops, garages, etc. The ones we used came in bright yellow, but a little black spray paint did the trick. You could re-use the whole thing by re-purposing the bulb socket and cord for your lamp, but we didn’t think about that till it was too late. So, we ended up with a couple of cord and sockets for another project.
Ethan took advantage of this phase to do some “graffiti” in the 7hills kitchen. 🙂